Moderator: Moderator Team
rplace wrote:As for your chiller I would think you would want the chiller level with the pump or below. The higher the pump has to move liquid the less GPMs you will get.
pclemon wrote:rplace wrote:As for your chiller I would think you would want the chiller level with the pump or below. The higher the pump has to move liquid the less GPMs you will get.
If you put the chiller below the pump isn't there going to be the propensity for the air in the chiller to come back up into the pump? I would have thought just the opposite - to put the chiller slightly higher than the pump to allow the air a natural path of escape.
rplace wrote:I think in pump terms is might be called head space. At any rate the higher is has to move the liquid the slower it moves it, right?
turbo_ale wrote:Craig, what is the purpose to drain the wort into the kettle, then pumped out of kettle by the pump ?
Monster Mash wrote:To filter out the trub. When I pump straight from the kettle the pump sucks hop material out of the pot and gets clogged, when I let it run out by gravity I can control the flow better and most of it stays in the pot. Any material that does get out goes into the grant which is in a constant whirlpool so it all goes to the center and stays there.
turbo_ale wrote:That is a great idea, but I think that would only be safe if the wort is hot? Your going through a CFC so it appears you cool after that grant?
I cool all my wort in brew kettle with RIC, so if I employed the grant my 70F wort would be exposed unless it was covered.
Users browsing this forum: No registered users and 2 guests