Monster Mill Grain Mill

General brewery equipment discussions.

Moderator: Moderator Team

Micro Brewery (2500 posts)
Posts: 4306
Joined: Mon Jul 21, 2008 12:13 pm
Location: Marlborough, MA
Re: Monster Mill Grain Mill

Post by pclemon » Mon Dec 01, 2014 1:59 pm

Willy wrote:Good to know....I think I'm going with a Millars. I called and talked with a guy for a while, about his mill and brewing stuff. This will be my first (and hopefully only) mill. Thanks for weighing in.
Hadn't heard of that one before. Had to look it up. Looks like a solid unit for a reasonable price. The only thing I found odd was their statement of "Crush 10 pounds in under 40 seconds". Not using that hand crank you won't. :D I like the idea of the sealed bearings over the bronze bushings.

I also had to look up 400 Series Stainless Steel. The only SS I've seen used in brewing is 300 series (304 or 316 specifically).

It is wiki - so I acknowledge it may not be 100% accurate but depending on what type of steel it is within the 400 series, will determine how corrosion resistant it is.

Post Reply